![]() The way to test these issues is to trace the voltage and see where it is not passing through. ![]() It is possible just the panel is bad but most of the time the board itself is the issue. It sounds like there was a short in the board when trying to operate. If there is power to the board and nothing on the panel working then most likely the board is the issue. Here’s what the experts had to say about your question: Now nothing no lights no relay or no motor, I do have power to board- any ideas? Reply First all lights came on, heard clicking in inside relay but no motor running. Every system will have a way to operate them without power.Ģ005 Winnebago Sightseer 29r Kwikee leveling system stopped working. There are other electric systems that use a wrench and extension to operate them. On electric systems you normally operate each jack at the motor by using an adapter and drill to raise and lower. Remove this sticker and normally you will see a hex head or 1/4″ port to insert a tool and using a drill will operate the pump. There is usually a sticker covering the port for the manual operation. Hydraulic systems can be operated at the pump directly. It depends on what system you have as to what is needed to operate them manually. There should be a way to manually operate them. ![]() Can you manually operate operate the jacks? Reply My low battery light is on and my jacks will not go up or down. My 2 Front Hydraulic Jack are slowly coming down while In route to location Reply ![]() Δ 49 Responses to “RV Leveling Jacks Not Working: Troubleshooting Tips”
0 Comments
Leave a Reply. |